IDP 700 Terminal Series - Hardware Guide
© SkyWave Proprietary 33 T206, Version 01
Figure 33 Attach the Cable Shroud to the Terminal
9.
Apply sealant to each cable entry point (Figure 34) and then apply a cable tie around
each pass-through hole.
Figure 34 Cable Tie to Pass-through Holes
4.6.2.1
Disconnect the FAKRA Connector
If you need to disconnect the FAKRA connector follow the steps below.
1.
Hold the FAKRA connector between your thumb and finger as shown in Figure 35.
2.
Press down firmly, with your thumb, on the raised section of the FAKRA thumb
release (Figure 35).
Pressing the thumb release will cause part of the release, closest to the transceiver
unit, to lift.
CAUTION
Do not pull on the FAKRA connector unless
the thumb release is down, or you may
damage the connector.
3.
Pull the FAKRA connector away from the transceiver unit while firmly holding
down the thumb release (Figure 35).
This causes the FAKRA connector to disconnect from the transceiver unit.
Summary of Contents for IDP 700 Series
Page 70: ...www SkyWave com ...
