This diagram shows the correct way to connect your battery to the B8+ charger while
charging in the balance charge program mode only.
WARNING:
Failure to connect as shown in this diagram will damage this charger.
The main battery leads must be connected along with the balance lead connector as
shown before charging your battery .
Charging
Lead
Connector
(4mm banana female)
Batt type/stop
To select
main program
To stop
the operation
Dec/inc
To selest
sub program
To alter
the value
LCD screen
(16chr.x2lines)
Universal
Connector
Pitch 2.45mm
Start/enter
To resume
or start
the operation
Input Power
Cable(DC11~18V)
USB Port
Temperature
Sensor port
Exterior of the unit
Exterior of the unit
Lithium polymer balance charge program connection diagram
06
07
Never leave the charger unsupervised when it is connected to its power supply. If any
malfunction is observed immediately terminate the process and refer to the operation
manual.
Keep the unit away from dust, damp, rain, heat, direct sunshine and vibration. Do not
drop it.
The circuit of the unit is designed to be powered by a 11-18 DC only.
This unit and the battery to charge or discharge should be set up on a heat-resistant,
non inflammable and non-conductive surface. Never place them on a car seat, carpet or
similar. Keep all the inflammable volatile materials well away from operating area.
Cooling vent of charger can not be covered or closed in order to keep good ventilation.
Make sure to completely understand the feature of batteries to be charged or
discharged. If the program is set up incorrectly, the battery may be severely damaged.
Especially for Lithium battery, it may cause fire or explode if charged incorrectly or
overcharged.
Voltage level: 1.2V/cell
Voltage level: 3.6V/cell
Max charge voltage: 4.1V/cell
Allowable fast charge current: 1C or less
Min. discharge voltage cut off level: 2.5V/cell or higher
Voltage level: 3.7V/cell
Max charge voltage: 4.2V/cell
Allowable fast charge current: 1C or less
Discharge voltage cut off level: 3.0V/cell or higher
Allowable fast charge current: 1C~2C depends on the
performance of cell Discharge voltage cut off level: 0.85V/cell
(NiCd), 1.0V/cell(NiMH)
Voltage level: 3.3V/cell
Max charge voltage: 3.6V/cell
Allowable fast charge current: 4C or less(e.g. A123M1)
Discharge voltage cut off level: 2.0V/cell or higher
Voltage level: 2.0V/cell
Max charge voltage: 2.46V/cell
Allowable fast charge current: 0.4C or less
Discharge voltage cut off level: 1.75V/cell or higher
Warning and safety notes
Warning and safety notes
