Program flow chat
10
11
INC
DEC
INC
DEC INC
DEC INC
B8+ will be operated with the default value of the essential user settings when it is
connected to a 12V battery for the first time. The screen displays the following
information in sequence and the user can change the value of parameter on each
screen.
When you are willing to alter the parameter value in the program, press
start/enter
key to make it blink then change the value with
Inc> or <Dec
key. The value will be
stored by pressing
start/enter
key once.
Initial parameter set up (Users set up)
Initial parameter set up (Users set up)
B8+ recognize the cell count of lithium battery
automatically at the beginning of charge or
discharge process to avoid from erroneous setting
by user. But deeply discharged battery can be
perceived incorrectly. To prevent the error, you can
set the time term to verify the cell count by the
processor. Normally, 10 minutes are enough to
perceive the cell count correctly. For the battery of
larger capacity, you may extend the time term. But if
you set the time term to long for the battery of
smaller capacity, the charge or discharge process
can be finished within the time term with the
erroneous cell count. This may cause the fatal result.
If the processor recognizes the cell count incorrectly
at the beginning of charge or discharge process, you
may extend the time. Otherwise, you had better use
with the default value.
This informs you of its designation.
The screen displays the nominal voltage of lithium
battery. There are three kinds of lithium battery:
LiFe(3.3V), Lilo(3.6V) or LiPo(3.7V). This is very
important so you have to check the battery carefully
and set it up correctly. If it is different from correct
value the battery explode during charge process.
