The charging current is getting smaller as the process goes to the near end term of
Lithium battery charging. To finish charging process earlier, this program eliminate
certain term of CV process. The charging current will goes to 1/5 from the initial value
to end the process while the normal charging goes to 1/10 during CV term. The charging
capacity may be a bit smaller than normal charging but the process time will be reduced.
You can set up the charging current and the
voltage of the battery pack being charged. As you
press
Start/Enter
button the voltage confirmation
will be displayed. And then, if you confirm the
voltage and current,
press
Start/Enter
button
again to start charging.
This shows the present state of "FAST"charging.
To stop charging arbitrary, press
Batt type/Stop
key once.
DEC INC
DEC INC
Batt type
stop
Start
Enter
`>3seconds`
number
of
cells
elapsed
time
charge
current
supplied
capacity
Current
voltage of
battery
‘
FAST
’
charging lithium battery
"FAST" charging lithium battery
This is for charging or discharging Lithium battery not to be used for the time being. The
program will determine to charge or discharge the battery to the certain voltage
depending on the voltage of the battery at its initial stage. They are different from the
type of the batter, 3.75V for Lilo, 3.85V for LiPo and 3.3V for LiFe per cell. If the voltage
of battery at its initial stage is over the voltage level to storage. The program will start to
discharge.
DEC INC
DEC INC
Batt type
stop
Start
Enter
`>3seconds`
number
of
cells
elapsed
time
charge
or
discharge
current
supplied
capacity
Current
voltage of
battery
You can set up the current and the voltage of the
battery pack to be charged. The current will be
used for charge or discharge the battery to reach
the "STORAGE" level of voltage.
The screen shows the present situation during
charge process. To stop charging press
Batt
type/Stop
key once.
‘
STORAGE
’
control of lithium battery
"STORAGE" control lithium battery
16
17
