64
221491AFA
SJ9233 RT, SJ9243 RT, SJ9253 RT, SJ9664 RT
Section 5 – Operation
Extend/retract the extension platform(s)
5.8 Extend/retract the
extension platform(s)
WARNING
Crush hazard. Do not retract the extension
platform(s) from the ground. If you do not obey,
there is a risk of death or serious injury.
WARNING
Push the emergency-stop button when you are at
the necessary location or elevation. This prevents
unintended MEWP movem
ent. If you do not obey,
there is a risk of death or
serious
injury.
1.
Remove the
lock-pin
on the floor of the
extension platform(s).
2.
Deploy the
extension handle
.
3.
Push or pull the
extension handle
1
to extend
or retract the extension platform(s).
4.
Retract the
extension handle
to lock the
extension platform(s) in position.
5.
Insert the
lock-pin
on the floor of the extension
platform(s).
1
5.9 Use the auto-level
(optional equipment)
WARNING
Look for overhead obstructions or other possible
hazards around the MEWP when you raise the
platform. Do not lower the platform unless the area
below is clear of personnel and obstructions. If
you do not obey, there is a risk of death or serious
injury.
WARNING
Tip-over hazard. Make sure the surface below the
tires and outrigger pads is firm and can hold the
MEWP and the rated load. Do not put the outrigger
pads on street drains, manhole covers, or other
unsupported surfaces.
If you do not obey,
there is
a risk of death or serious injury.
Level the MEWP
1.
Fully lower the platform. Refer to
Section
5.3
and
Section 5.4
.
2.
Move the
auto-level/differential lock
switch to
the auto-level position.
3.
Squeeze the
function-enable
switch and
push the
controller handle
to deploy all four
outriggers. The light of the level indicator shows
the auto-level outrigger condition. Refer to
Figure 08.
Auto-level light
Outrigger condition
Off
The outriggers are fully
retracted. The outriggers are
not active.
Flashing slowly
Indicates the outrigger
extension or retraction.
Flashing quickly
The outriggers are extended
and the MEWP is not level, or
there is an outrigger or auto-
level function error.
On
The outriggers are extended
and the MEWP is level. The
light is on while the auto-level
function is active only.
Figure 08
Auto-level outrigger condition
Summary of Contents for SJ9233 RT
