Skyjack SJ6832 RTE Series, Operation Manual

Page: 48 / 112

48
SJ6832 RTE
221844ACAI
Section 4 – Inspections Before Operation Function Tests
2
3
1
4.3-20 Do a test of the auto-level (optional
equipment)
Refer to
section 5.11
for the auto-level operation.
NOTE
Make sure that you:
▪
Park the MEWP on a firm, level surface. Remove
all obstructions.
▪
Fully lower the platform.
▪
Fully retract the outriggers.
WARNING
If the outrigger interlocks fail to operate correctly,
lock and tag the MEWP. Remove the MEWP for
servicing. Only a qualified service technician must
repair the MEWP. If you do not obey, there is a risk
of death or serious injury.
1.
Move the
lift/off/drive
switch
1
to the lift
position.
2.
Move and hold the
auto-level enable
switch
2
in the enable position.
3.
Move and hold the
auto leve
l switch
3
in the
extend position to extend the outriggers until
all four outriggers are on the ground and the
platform is level.
WARNING
Look for overhead obstructions or other possible
hazards around the MEWP when you raise the
platform. Do not lower the platform unless the area
below is clear of personnel and obstructions. If
you do not obey, there is a risk of death or serious
injury.
4.
Raise the platform by approximately 0.3 m.
▪
Result:
The platform raises.
5.
Fully lower the platform.
▪
Result:
The platform fully lowers.
6.
Move and hold the
auto-level enable
switch
2
in the enable position.
7.
Move and hold the
auto leve
l switch
3
in the
retract position to fully retract all four outriggers.
▪
Result:
All four outriggers fully retract.