Skyjack SJ6832 RTE Series, Operation Manual

Page: 35 / 112

35
SJ6832 RTE
221844ACAI
Visual and daily maintenance inspections Section 4 – Inspections Before Operation
4.2-4 Wheels/Tire assembly
Do the inspection that follows:
7
Wheel/tire assembly
▪
Do a check on all the tire treads and sidewalls
for cuts, cracks, and unusual wear.
▪
Do a check on each wheel for damage, and
cracked welds.
▪
Make sure the wheels are correctly aligned
vertically and horizontally.
▪
Make sure there are no loose or missing parts.
▪
Make sure there is no visible damage.
WARNING
Do not use tires other than the tires that Skyjack
specifies for this MEWP. Do not mix different types
of tires or use tires that are not in good condition.
Only replace the tires with the same types that are
approved by Skyjack. The use of other tires can
make the MEWP less stable. If you do not obey,
there is a risk of death or serious injury.
8
Wheel nuts
▪
Make sure the wheel nuts are installed and are
tight.
4.2-5 Base
Do the inspection that follows, and make sure:
1
Base weldment
▪
There are no cracks in the welds or structure.
▪
There are no signs of deformation.
2
Steer cylinder
▪
The steer cylinder assembly is correctly
installed.
▪
There are no loose or missing fasteners.
▪
There is no visible damage.
3
Tie rod
▪
There are no loose or missing parts.
▪
The tie rod end studs are attached and tight.
▪
There is no visible damage.
4
Emergency-lowering access rod
▪
The rod is correctly attached and has no
visible damage.
5
Ladder
▪
There are no loose or missing parts.
▪
There is no visible damage.
6
Outriggers (optional equipment)
▪
There are no loose or missing parts.
▪
There is no visible damage.
1
2
3
4
5
8 7
6