Page 76
December 2007
SJ 63AJ
1
8
2
6
5
4
3
7
2
3
4
5
No.
Label Pictorial
Description
1
Winching/Towing/Pushing Procedure
Refer to Operating manual.
1. Block or chock wheels to prevent MEWP from rolling.
2. Turn main power disconnect switch to off position.
At engine side:
3. Locate bypass valve (marked with yellow colour) on inboard
side of drive pump.
4. Rotate bypass valve flat using pliers or 1/4” (7mm) wrench by
90 degrees (clockwise).
At hydraulic tank side:
5. Locate brake valve and pump.
6. Push in black knob.
7. Pump by slowly pushing red knob in and out until 300 psi/
21 bar shows on the gauge (if equipped). Brake is now released.
Refer to
Section 2.5 Winching & Towing Procedure
.
8. A) Remove blocks from wheels.
B) Push/tow/winch to desired location.
9. Block or chock wheels to prevent MEWP from rolling.
At hydraulic tank side:
10. Reset brake by pulling out black knob.
At engine side:
11. Close bypass valve by rotating 90 degrees
(counterclockwise) to normal condition (flat is parallel to shaft
axis).
NOTE
Before operation, ensure all blocks are removed from
wheels.
Engine Compartment
Labels
Section 5
