Ski-Doo Scandic Tundra Series, Operator'S Manual, Page: 78 / 115

MAINTENANCE PROCEDURES
mmo2007-009-064_a
PULL BULB AND REPLACE
Headlights Beam Aiming
Remove gauge, refer to
HEADLIGHTS
BULB REPLACEMENT
. Turn knob to
adjust beam height.
mmo2007-009-023_a
TYPICAL
1. Knobs
Taillight Bulb Replacement
1. Remove taillight housing by care-
fully pulling on lens at both ends.
mmr2008-039-012_a
TYPICAL - CAREFULLY PULL OUT AT
CORNERS
NOTICE
Taillight housing is held
in place by two plastic pins inserted
in rubber grommets.
If taillight
housing is forced too far sideways
when removing, mounting pins may
break and housing will have to be
replaced. Do not pull taillight hous-
ing out too far to avoid damaging
wiring.
mmr2008-039-006_a
1. Taillight housing retaining pins
2. Retaining grommets
3. Light wire harness
2. Rotate bulb socket counterclock-
wise to remove it from taillight hous-
ing.
3. Push in and rotate bulb counter-
clockwise to remove it from its
socket.
4. Install the new bulb by pushing it in
the socket and turning it clockwise.
NOTE: Note position of bulb locking
pins on its base, and socket alignment
key.
mmr2008-039-008_a
1. Bulb locking pins
2. Bulb holder alignment key
76
______________