Ski-Doo Scandic Tundra Series, Operator'S Manual

Page: 69 / 115

MAINTENANCE PROCEDURES
riod, burred or rusty sheave, oil on belt
or distorted spare belt. Contact an au-
thorized Ski-Doo dealer.
Drive Belt Replacement
Drive Belt Removal
1. Remove tether cord cap and key.
2. Open LH side panel, refer to
BODY
.
3. Remove belt guard, refer to
BELT
GUARD REMOVAL .
4. Insert the driven pulley expander
provided in the tool kit in the
threaded hole on the adjuster hub
as shown.
mmo2010-004-010_b
1. Threaded hole
mmo2010-004-008
5. Open the driven pulley by screwing
the tool in.
6. Remove the belt by slipping it over
the top of the driven pulley, then
over the drive pulley.
Drive Belt Installation
1. If necessary, open the driven pul-
ley, refer to
DRIVE BELT REMOVAL
above.
2. Slip the belt over the drive pulley,
then over the driven pulley.
NOTICE
Do not force or use tools
to pry the belt into place, as this
could cut or break the cords in the
belt.
NOTE: The maximum drive belt life
span is obtained when belt is installed
with arrows in the direction of rotation.
mmo2008-003-045_a
1. To be pointed in the direction of rotation
3. Unscrew and remove the driven pul-
ley expander from the pulley.
4. Rotate the driven pulley several
times to properly set the belt be-
tween the sheaves.
5. If a new belt was installed, adjust
the belt height. Refer to
DRIVE
BELT HEIGHT ADJUSTMENT
be-
low.
6. Install belt guard, refer to DRIVE
BELT GUARD INSTALLATION
.
7. Close side panel, refer to
BODY
.
Drive Belt Height Adjustment
(Screw Type Pulley Adjuster)
The drive belt height must be checked
every time a new belt is installed.
To adjust the drive belt height, proceed
as follows:
1. Remove tether cord cap and key.
_______________
67