Form 40017 Rev 1906
Page 24 of 26
Maintenance
Change the Battery Pack
Review Notes and Cautions on page 4 before proceeding.
1.
Turn o
ff
the pump by
pressing the Power On/O
ff
bu
tt
on located on the top of the non-running pump
(Figure 1)
; the screen will go
dark.
2. Use a 1.5-mm hex key (provided with pump) to loosen two safety screws on the back of the ba
tt
ery pack housing
(Figure 1)
.
3. Orient the pump so that the belt clip faces upward and the pump inlet points left. Using your
fi
ngers, grip the ba
tt
ery pack housing
just above its top screw and just below its bo
tt
om screw and lift up against the belt clip. Once the housing clears the pump case, pull
it to the right, away from the pump case.
4. If replacing the ba
tt
ery pack with a new ba
tt
ery pack (Cat. No. P76303), dispose of the used ba
tt
ery promptly and according to all
state and local regulations.
Do not disassemble the battery pack. Do not dispose of in
fi
re. Dispose of used batteries promptly according to all state and local recycling
or waste regulations.
5. Install a new ba
tt
ery pack or re-install an existing ba
tt
ery pack.
a. Align ba
tt
ery pack housing with pump case.
b. Use the back of the ba
tt
ery pack housing to push up the belt clip until the ba
tt
ery pack is aligned with the pump case and presses
easily into place. Ensure the ba
tt
ery pack housing
fi
ts
fl
ush with the pump case.
c. Use a 1.5-mm hex key to tighten two screws on back of the ba
tt
ery pack housing. Tighten screws in an alternating fashion.
d. Charge the ba
tt
ery pack completely before use.
See Charging the Ba
tt
ery Pack on page 3.
Note:
When the ba
tt
ery is rea
tt
ached to the pump, the screen will light and then go black as the pump performs a
fi
rmware check. This
lasts approximately 20 seconds and the Main Menu will display as soon as the check is completed.
Clean the Touch Screen
Use a soft, clean, and dust-free cloth to remove
fi
ngerprints from the touch screen.
Do not use alcohol to clean the screen.
Troubleshooting
Troubleshooting Guide
Issue
Possible Solutions
The display on the pump is frozen.
1. Press the Power On/Off button to shut off the pump.
2. Remove the battery
(see Maintenance above)
3. Reinstall the battery.
User may replace external components such as the inlet
fi
lter, battery, screen protector, and/or belt clip. Service must be performed by
SKC to maintain performance and intrinsic safety rating. Warranty is void if pumping compartment is opened by user.
