Form 40017 Rev 1906
Page 2 of 26
Introduction
Checking Pump/Kit Contents
Use the following table to verify that you received all items associated with the Cat. No. ordered. If you are missing items, contact SKC
at 800-752-8472 (U.S. only) or 724-941-9701.
If you ordered Cat. No.
Your Package Should Contain
220-1000TC
Pocket Pump TOUCH only*
with Li-Ion battery and screwdriver, requires charger;
see kits or charger below
220-1000TC-C
Pocket Pump TOUCH with Charger*
includes pump as described above and single charger (cable and wall cube with
U.S. plug)
100-240 V
220-1000TC-S
Pocket Pump TOUCH Starter Kit*
includes pump and single charger as described above, 3 feet (0.9 meter) of Tygon
tubing, and collar clip with cable tie
100-240 V
220-1000TC-K
Single Pump Kit*
†
includes pump and single charger as described above, and Type A single tube holder, in a soft-sided
nylon carry case
100-240 V
220-1000TC-K5
5-pack Pump Kit*
includes 5 pumps as described above, 5 single chargers (cables and wall cubes with U.S. plug), and
5 Type A single tube holders, in a Pelican case
100-240 V
220-1000TC-K5D
5-pack Deluxe Pump Kit*
includes 5 pumps as described above, 5 Type A single tube holders, 5 single charging cables
(no wall cubes), one 5-port USB charging hub with power cable (U.S. plug), and 1 DataTrac Pro USB Bluetooth Adapter
(software available via free download), in a Pelican case
100-240 V
Pocket Pump TOUCH requires ¼-inch ID tubing.
* Pocket Pump TOUCH pumps contain Li-Ion ba
tt
eries and are subject to special shipping regulations.
† Single kits are also available in hard-sided Pelican case. Contact SKC.
Quick Guide
Charging the battery:
Insert USB connector on cable into USB port on supplied wall adapter. Plug into 100 to 240-V outlet. Hover
magnetic charging connector on cable closely over contact on back of pump until engaged and LEDs on contact and cable light blue.
Full charge is achieved in approximately 10 hours.
See Charging the Battery Pack on page 3 for details.
Turning on:
Press Power On/Off button on top of pump; the
screen will light and Flow screen will display.
Using the touch screen:
Use a
fi
ngertip to gently touch
screen buttons in the indicated active zones.
Accessing Main Menu:
Touch
.
Navigating from Main Menu
Desired Operation
Button to Touch
Result
Access device settings
History, Clock, Units, and Screen sub-menus display. Touch
buttons to view and choose setting options within each.
View information about the pump
Firmware version/date of pump manufacture, and pump
serial number display.
Access
fl
ow rate, calibration, and sampling
Flow, Presets, and Advanced (constant pressure) sub-menus
display. Touch buttons to view and choose mode or options
under each.
Basic Pump Operation
Run pump:
From Main Menu: Touch Sample >Flow >Run
Note:
Pressing the Power On/Off button on top of pump will dim and lock screen. To undim and unlock, press Power On/Off
button again.
Pause pump:
Touch Pause
. Touch Run
to resume.
Stop pump:
Touch Stop
. Sample Summary will display. Touch
to return to Main Menu.
Turning off:
Press Power On/Off button on top of pump; the screen will go dark. The pump will power off automatically after
fi
ve minutes of no activity.
Active Touch Screen Areas
