Form 40017 Rev 1906
Page 18 of 26
To sample using a single sorbent tube, multiple sorbent tubes, or sample bag
* Charge pump battery completely before sampling.
* Use of an unapproved battery and/or charging cable could damage the pump and will void any warranty.
* If using sample tubes as media, calibrate/verify pump
fl
ow rate before and after each sampling operation using the tube holder and
pump used for sampling.
1. Ensure pump is calibrated to the method-speci
fi
ed
fl
ow rate.
See To calibrate on page 13.
From Main Menu:
Touch Sample
> Touch
Flow
or
Advanced
2. Ensure calibrator and tubing have been removed and representative
method-speci
fi
ed sampling medium used for calibration has been replaced
with newly opened unexposed method-speci
fi
ed sampling medium to
complete the sampling train.
For bag sampling
a. Use PTFE tubing to
connect pump exhaust
(Figure 1)
to the bag
fi
tting.
See bag operating instructions.
b. Unscrew cap on pump exhaust to remove it and screw in supplied exhaust
fi
tting or optional Quick-connect
Bag Sampling Adapter accessory.
c. Attach tubing from the bag to the
fi
tting or adapter on the pump exhaust.
3. On the pump, choose from a manual sample, timed sample, or sample preset (presets are uploaded to the pump from DataTrac Pro
Software).
See To set up and run a manual sample below, To set up and run a timed sample on page 20, or To run a sample preset on page 21.
To set up and run a manual sample
1. Connect pump to sampling train.
See To sample, Step 2, above.
2. Run sample as follows:
From Main Menu:
Touch Sample
> Touch
Flow
or
Advanced
> Touch Run button in Flow Menu to
run pump in constant
fl
ow.
> Touch Run button in Advanced Menu
to run pump in constant pressure.
> Touch Run button in Flow Menu to
run pump in constant
fl
ow.
> Touch Run button in Advanced Menu
to run pump in constant pressure.
