2
•
The delays in the workings due to
breakdown detection and external start/stop
orders.
•
Input no.1 used as Start or as Start/Stop.
•
The fact of relating a time programme with
input number 1 (e.g. to start by time and
level).
2. INTRODUCTION
When installing the unit, the first step to take is
the feeding according to the CONNECTIONS chapter
of this manual (“feeding connection” and “common
connection”).
Then go to the CONFIGURATION chapter to start
it according to the specific needs of every case.
Use the codes, which appear at the frontal part of
the unit to enter data into the programmer or to
consult them.
The main menu is the starting point. Press the
“C” and “+” key at the same time to access it.
The sections of consultation, programming,
change of time, manual activation of programmes and
manual activation of sectors are accessed from the
main menu. The values displayed in these sections go
with an identifying code.
To choose an option from this menu, press the
“+” or “-“ keys until the screen shows the code of the
desired option. Press the “C” key to enter this option.
Press the “+” and “-” keys to modify the values
displayed on the screen, which increase or decrease
the value displayed in that moment. If the key is
pressed for more than two seconds, there is a fast
increase/decrease.
Press the “+” (YES) key to answer any question
in an affirmative way and the “-” (NO) key to answer in
a negative way.
Press the “C” key to confirm the displayed value
and change the parameter.
Press the “C” and “+” key at the same time to
leave the option where you are and go to the main
menu.
Figure 1. Keyboard
