11
7. USE
This chapter is normally used by the user to
programme his/her Agrónic Diesel, once the
connections and the configuration have been done by
the installer.
7.1. MAIN MENU
The main menu is the first thing displayed on the
screen when the programmer is fed.
Two letters are displayed at the central part of the
screen. These letters represent the possible options.
Use the “+” and ”-“ keys to go from one option of the
menu to the next one. Use the “C” key to enter the
sections of the displayed option.
Example 1.- Main Menu screen
C O
The following table shows the meaning of the
letters which appear in the main menu.
Table 4 – Main Menu options
MENU
FUNCTION
CO
Consultation
P1
Entry of the values of programme 1
P2
Entry of the values of programme 2
P3
Entry of the values of programme 3
P4
Entry of the values of programme 4
P5
Entry of the values of programme 5
HO
Change clock time
AP
Manual activation or stop of programmes
AS
Manual activation or stop of sectors
Press the “C” and “+” keys at the same time to
go back to the Main Menu from any option.
Every option of the menu has one or more
sections. In order to identify these sections, a letter,
indicating the option we are in, and a number,
identifying every section of the option, are displayed at
the left of the screen. If an option has just got one
section, the code corresponds to the letters of the
option.
The meaning of every code and its sections are
going to be explained in detail in the following points
of the manual.
7.2. CONSULTATION (Cx)
At Consultation we can see the general state of
the programmer (breakdowns, conditional stop, time)
and, specially, all the information about the evolution
of the programme which is activated.
Table 5 –Consultation option sections
CODE FUNCTION
C1
Unit time, breakdown, conditional stop.
C2
Time left before the first sector is activated.
C3
Time left before the second sector is
deactivated.
C4
Activated inputs.
C5
Total time the engine has been working.
Press the “C” key to go from one code to the
next one. Press the “C” and “+” keys at the same time
to go back to the main menu.
-
Code C1: Under normal conditions the unit clock
time is displayed. If there is a conditional stop, the
letters “P CO” would be displayed. If there is a
breakdown in the unit: “EA” will appear. if the
breakdown comes from input 4; “AA” will appear. If
the start attempts of the engine have gone by
without being able to start it (the number of start
attempts is configurable) and “PA” will be
displayed if, on starting the engine, it is detected
that the engine has been started without using the
programmer or a stop in the engine is detected
when it should be working.
When anomalies are displayed on the screen,
their initials blink.
- Code C2: It shows, in hours and minutes, the time
left for the working of the first sector to finish. If the
programme or sector have been activated
manually, a spot appears to the left of the time.
Example 2.- Consultation screen
C 2 .0 1:1 2
- Code C3: It shows, in hours and minutes, the time
left for the second sector to finish. If the
programme or sector have been activated
manually, a spot appears to the left of the time.
- Code C4: It shows the input state, independently of
the programmed delays for every one of them. The
input number appears if it is activated and a dash if
it is not.
- Code C5: It shows the total number of hours the
engine has been working. The maximum number is
9999, after this number it starts again at 0. A spot is
displayed to the left of this number if the
