Sirona inEos Blue, Operating Instructions Manual, Page: 37 / 52

63 33 632 D3446
D3446
.
201.02.03
.
23 07.2011 37
Sirona Dental Systems GmbH 11 Performing 3D acquisition
Operating Instructions Sirona Dental CAD/CAM System
Acquisition with the foot switch
Taking the scan
1. Click the Free Scan icon.
ª
A section of the model appears in the the live image.
2. Slide the model until you can begin scan acquisition on a distal side.
3. Focus the image with the rotary knobs for height adjustment; see
Focusing the image [ → 33].
4. Single-click the Start button of the inEos Blue.
ª
The first scan is taken and the crosshairs are displayed blue.
5. Add additional scans from adjacent areas: Move the model freely on
the table until you have reached the next acquisition position. As soon
as the model stops moving, the camera is automatically released.
You can turn the model on the shifting plate by up to 30°.
Tip:The new image must overlap approximately one half of the
previous image. If necessary, you can turn the model by 180°.
6. Repeat step 5 until all of the required scans have been taken.
If you do not require any further free scans (including detail scans), you
can change to the next acquisition mode; see Rotational scans [ → 38].
11.3.3 Performing detail scans
Performing detail scans
You can acquire detail scans at any time during the free scan.
1. Tilt the model no more than 30° in the desired direction.
Tip: You can turn the entire model on the shifting plate by 180° if
necessary.
2. Double-click the Start button of the inEos Blue.
ª
An image is acquired.
3. Repeat steps 1 and 2 until all of the required scans have been taken.
Tip: Align the scanned area as for the overview scan. Tilt the model holder
to an angle of up to 30°.
Multiple scans are required for angles larger than 30°. Start with a small
angle and take additional exposures right afterwards with a larger angle.
Actuate the foot switch
once
A single exposure will be acquired. The model
must be motionless and set in focus.
Press and hold down
the foot switch
The crosshairs turn blue. The system will
automatically acquire new images after you
move the model or reset the image focus.
To interrupt the automatic scan, simply let go
of the foot switch. The crosshairs turn green.
You can acquire additional exposures by
reactivating the foot switch.
Tip: When taking detail scans, interrupt the
automatic scan to continue at a different model
location. This location must overlap roughly
one half of the image previously scanned.