12
Tour with Vehicle Kit User Guide
Installing the Vent Mount:
IMPORTANT!
To make the cable connections easier, wait until after you have connected
all the cables to the dock before you attach the Vent Mount to a vent .
1.
Locate a vent with horizontal louvers sturdy enough to hold your
Power
Connect Vehicle Dock and Tour Radio .
2.
If the vent louvers in your vehicle are recessed, you may need to use
the longer vent clamps with the Vent Mount . If so, remove the shorter
vent clamps and install the longer ones into the Vent Mount . Be sure to
observe the orientation of the vent clamps as shown, and replace both
vent clamps .
3.
Attach the Vent Mount to the
Power
Connect Vehicle Dock using the 4
provided screws .
4.
Before you attach the Vent Mount to the vent, skip ahead and finish the
remainder of the vehicle installation so that the cables are attached to
the dock .
NOTE!
For greater clarity, the next illustration does not show the dock
attached to the Vent Mount, however, the dock should be attached before continuing .
5.
Once the cables have been attached to the dock, push the Vent Mount onto the vehicle vent as
shown (1) until it hooks on the rear of the vent louver (2) .
6.
Rest the foot against the bottom of the vent (2), and adjust the tilt of the Vent Mount by
repositioning the foot to the other adjustment hole (3) .
TIP!
To remove the Vent Mount, push the mount into the vent . Then lift up until disengaged
from the rear of the vent louver, and remove the Vent Mount .
Extended Vent Clamps
Short Vent
Clamps
Vent Mount
Rear View
Round End
Orientation
Vent Mount Rear View
Slide Left Clamp to
Hole in Center
Pull Clamp Out
Towards You
Insert Round End
of the Extended
Clamp in the
Center Hole
Slide Clamp to Left
to Complete
Installation
Repeat to Replace
Right Clamp
Dash
Dash
PUSH
Dash
Vent
Louver
Vent
Vent
HOOKED
TILT
ADJUSTMENT
HOLES
FOOT
1
2
3
UDIO
ANT
FM
Installation
