BACK
MANUAL
SINTERIT ATEX VACUUM CLEANER
Cleaning the printer.
Do you want to use Vacuum Cleaner or
clean the printer using manual procedure?
Image 24. When cleaning the printer, we recommend selecting
the Sinterit ATEX Vacuum Cleaner path on the printer screen.
Image 25. Pouring the contents of the IO Box
onto the Powder Chamber grid.
12. Starting with the external layers of the cake, crush it
and push the powder through the grid. Watch out for
prints inside the cake body (image 26).
Image 26. Pushing the powder through the Powder Chamber grid.
13. In the end, check the amount of powder in the Powder
Chamber. You can lift the grid and, with a Powder Wiper,
clean the walls of the chamber from the powder deposited
(image 27).
Do not remove the Powder Feeding Screw guard
22
inside the chamber!
22
Image 27. Cleaning the Powder Chamber walls
from embedded powder.
14. The overflow of powder (or when the powder is
solidified and does not sieve) and collected on the
Powder Feeding Screw guard
22
can be pressed
into the chamber with the Trowel (image 28). Only
the powder below the guard will be transported and
sucked in.
15. Remember to put the grid back on the Powder
Chamber
1
.
Image. 28. Use the Trowel to push the powder
through the Powder Feeding Screw guard.
16. The extracted prints should be cleaned above the
Fine Dust Chamber grid
1
with brushes, stainless
steel probes, and spatulas, and placed on the Worktop
(or on the Foldable Tray on the right - if there is no
sandblaster placed there) (image 29).
2
Image 29. Thorough cleaning of prints above the Fine Dust Chamber.
25 | POWDER HANDLING STATION Manual
Summary of Contents for POWDER HANDLING STATION
Page 2: ......
