For easy and safe unpacking you will need it:
Two persons
Service wrench 17/10
F
(1 point - size 17,
2 points - size 10)
Bookbinding knife,
Phillips screwdriver
The PHS device is delivered on a 1200 x 800 [mm] pallet, protected by a cardboard box filled with foams and foils.
1. Unwrap the security foil from the pallet.
2. Remove the security cardboard and remove the foam fillers and edge protectors.
3. Visually check that the device has not been damaged during transport (visible dents, scratch damage to the casing).
If any, stop the installation and contact Sinterit Technical Support (https://www.sinterit.com/support-page).
4. Remove the foil protected elements of the Metal shelf
13
and the PHS User Manual from 2nd Drawer
8
.
5. On the pallet, under the PHS device, are two elements
of the Slope ramp
A
. Cut off the clips holding the
ramp components
A
Image. 5. During transport, the Slope ramp
is located under the PHS device.
6. Place the Slope ramp
A
next to the pallet, always on the side of the Sifting module door (image 6).
7. Match both ends of the Slope ramp
A
with the guide rail on a pallet
B
. Check the connection to ensure that it does
not disconnect during the PHS downhill (image 7).
A
A
3 m
Image. 6: Correct positioning the Slope ramp to the pallet.
15 | POWDER HANDLING STATION Manual
Summary of Contents for POWDER HANDLING STATION
Page 2: ......
