C.
PERSONAL PROTECTION
ATTENTION!
•
Wear individual protections (Protective gloves, Protective Glasses, Protective Dust Mask).
•
Hearing protection is required when working with a PHS device. Staying with the device
unprotected for long periods may reduce attention and impair hearing.
•
To prevent dust from being inhaled at all times, always wear a dust mask. When entering a PHS
room, pay attention to the solid particles that are released during sieving.
•
Inhalation of the dust can cause serious lung problems.
ATTENTION!
•
The operator must always wear antistatic clothes and shoes.
•
The floor in the working area must be antistatic.
STOP!
•
Do not wear untied hair, loose or hanging clothes such as ties, scarves, or torn
clothes that could become trapped by the PHS device.
•
Do not place the Suction hose close to the body, especially to sensitive areas
such as eyes, ears, and lips!
D.
POWER SUPPLY AND GROUNDING SYSTEM
WARNING!
•
Before plugging in, make sure the power voltage and frequency are those shown
on the machine plate.
•
When an extension cord is used for the power supply of the product, make sure
that the total power consumption of all devices connected to it does not exceed
the extension cord’s limit. Also, make sure that the total current drawn by
connected equipment does not exceed the ampere rating for the AC wall outlet.
•
The PHS device should be connected to an electrical installation protected with
an overcurrent switch with this parameters:
•
Characteristics: type B
•
Rated current value: 10A
WARNING!
•
Use only the Power cable supplied with the product.
•
Do not use power cables from other devices! Using the power cables from
other devices or connecting the power cables supplied with the product to other
devices may cause fire or electric shock.
•
The device power plug should be suitable for the power outlet.
•
The power cable should be placed in such a place that it is not rubbed, cut,
pulled, or twisted.
•
Pay special attention to the fact that the Power cable is not bent at the points of
connection of the device.
•
During use, mind the power supply cables and avoid crushing or pulling these.
•
Periodically check the mains power cable to ensure it is not damaged.
•
In the event of the cable being replaced, make sure it is protected against water
spray and check mechanical strength.
•
Disconnect the Power cable whenever it is planned to shift/transfer the machine.
7 | POWDER HANDLING STATION Manual
Summary of Contents for POWDER HANDLING STATION
Page 2: ......
