Sindoh A610 Series, Service Manual

Page: 193 / 218

189
followings:
- Input Sensor
- Exit Sensor
- Tray1 Empty Sensor
- Tray2 Empty Sensor
- MPT Empty Sensor
- Front / Rear Cover
To run the Sensor Test:
1. Select Hardware Test from diagnosis mode.
2. Select Sensor Test. (Entering sensor test mode completed)
When 6 sensors and switches listed above change its status during the sensor test mode,
the status will be displayed on LCD.
For example, if you close and open cover continuously during the sensor test mode and
‘Cover open/close’ message appears normally, the status of cover switch is normal. If
message is not displayed properly, there’s a problem with cover switch status and it needs
to be inspected.

Solenoid Test
This test is used as to check if all solenoids installed in the machine operate properly or not.
The solenoids that can be checked from the solenoid test mode are the followings:
-
MPT Pick up Solenoid
-
Duplex Solenoid
To run the solenoid test:
1. Select Device Test from Diagnosis Mode.
2. Select Solenoid Test. (Entering solenoid test mode completed and start test)
When solenoid test starts, 3 solenoids listed above are turned on at the same time, then