E Q U O B O X R T U - M o d B u s
–
U s e r G u i d e R e v . 2 . 2
S I N A P S I S . r . l . |
V i a d e l l e Q u e r c e 1 1 / 1 3 - 0 6 0 8 3 B A S T I A U M B R A ( P G )
–
I t a l y
T . + 3 9
0 7 5 8 0 1 1 6 0 4
- F . + 3 9
0 7 5 8 0 1 4 6 0 2 |
w w w . s i n a p s i t e c h . i t
i n f o @ s i n a p s i t e c h . i t
38
o
Open: commands to open
o
Close: commands to close
o
Pulse: generates a pulse
•
Output 2: when an event occurs, you can enable an operation according to the device connected to
Output 2, such as:
o
Open: commands to open
o
Close: commands to close
o
Pulse: generates a pulse
•
Add to Log: stores the alarm in the meter’s log
•
Send Email: sends an email notification in the event of an alarm (Ref. Chapter 5.3, 8.3)
•
Save: Press Save to save the configuration
16.5
Condition set according to the value out of range
Select the Out of range item.
Figure 44 - Completing the creation of an event
The cells to be filled out are:
•
Event Name: enter the name of the event being created
•
Data Type: select the type of meter data. The data you can select are those that have already been set
for every single meter. For more information, refer to Chapter 15
•
Lower threshold: select the lower alarm threshold. The value can be both positive or negative
•
Upper threshold: select the upper alarm threshold. The value can be both positive or negative
•
Dead band: enter the value for which the condition does not occur. This feature allows the system to
react with a certain delay to the actions to be taken based on the values measured beforehand
Figure 45
–
Dead band
•
Event closure notification: sends an email notification whenever an event is closed
•
Output 1: when an event occurs, you can enable an operation according to the device connected to
Output 1, such as:
o
Open: commands to open
o
Close: commands to close
o
Pulse: generates a pulse
