E Q U O B O X R T U - M o d B u s
–
U s e r G u i d e R e v . 2 . 2
S I N A P S I S . r . l . |
V i a d e l l e Q u e r c e 1 1 / 1 3 - 0 6 0 8 3 B A S T I A U M B R A ( P G )
–
I t a l y
T . + 3 9
0 7 5 8 0 1 1 6 0 4
- F . + 3 9
0 7 5 8 0 1 4 6 0 2 |
w w w . s i n a p s i t e c h . i t
i n f o @ s i n a p s i t e c h . i t
37
•
Event closure notification: sends an email notification whenever an event is closed
•
Output 1: when an event occurs, you can enable an operation according to the device connected to
Output 1, such as:
o
Open: commands to open
o
Close: commands to close
o
Pulse: generates a pulse
•
Output 2: when an event occurs, you can enable an operation according to the device connected to
Output 2, such as:
o
Open: commands to open
o
Close: commands to close
o
Pulse: generates a pulse
•
Add
to Log: stores the alarm in the meter’s log
•
Send Email: sends an email notification in the event of an alarm (Ref. Chapter 5.3, 8.3)
•
Save: Press Save to save the configuration
16.4
Condition set according to the minimum value acquired
Select Min Value.
Figure 42 - Completing the creation of an event
The cells to be filled out are:
•
Event Name: enter the name of the event being created
•
Data Type: select the type of meter data. The data you can select are those that have already been set
for every single meter. For more information, refer to Chapter 15
Errore. L'origine riferimento non è
stata trovata.
•
Alarm threshold (Min): select an alarm threshold. The value can be both positive or negative
•
Dead band: enter the value for which the condition does not occur. This feature allows the system to
react with a certain delay to the actions to be taken based on the values measured beforehand
Figure 43
–
Dead band
•
Event closure notification: sends an email notification whenever an event is closed
•
Output 1: when an event occurs, you can enable an operation according to the device connected to
Output 1, such as:
