Simplicity 7800354, Operator'S Manual

Page: 33 / 312

Storage (over 30 days)
At the end of each year, prepare the unit for storage as
follows.
1. Drain the fuel from the carburetor and the fuel
tank. Change the engine oil. See the engine
manufacturer’s instructions.
2. Clean the entire unit.
3. Charge the battery.
Order Replacement Parts
The replacement parts are shown either on the back
pages of this Operator’s Manual or in a separate Illus-
trated Parts List (IPL) catalog.
Use only manufacturer’s authorized or approved re-
placement parts. Do not use attachments or acces-
sories not specifically recommended for this unit. In
order to obtain proper replacement parts you must
supply the model number of your mower (see name-
plate).
Replacement parts, except for the engine, transmis-
sion, transaxle or differential, are available from the
store where the mower was purchased or a service
shop recommended by the store.
Warranty service is available only through Authorized
Service Dealers. Locate your nearest dealer in our
dealer locator map at
www.BRIGGSandSTRATTON.com.
Replacement parts for the engine, transaxle, or trans-
mission, are available from the manufacturer’s author-
ized service center found in the commercial pages of
the telephone directory. Also, see the individual engine
or transmission warranties to order replacement parts.
When ordering the following information is required:
(1) Model Number
(2) Serial Number
(3) Part Number
(4) Quantity.
If you are not able to get parts or service in the manner
given above, then contact:
Briggs & Stratton UK Ltd
Road Four, Winsford Industrial Estate
Winsford, Chesire
CW7 3QN
www.BRIGGSandSTRATTON.com
Maintenance
en
Replace the Fuse
If the fuse is blown, the engine will not start.
Remove the fuse and replace with a 15 amp
automotive fuse.
33
Bagger Cover Adjustment
NOTE: The bagger cover should come properly ad-
justed from the factory.
1. Check the alignment of the plastic bagger cover
with the rear trim of the body.
2. If necessary, adjust the bagger cover by tightening
or loosening the bolts at the rear plate (see F Figure
39). Tightening the bolt will move the bagger cover
closer to the rear trim and loosening will increase
the space between the parts.
Figure 39