Simplicity 7800354, Operator'S Manual

Page: 20 / 312

20
Start the Engine
WARNING
The electrical system has an operator presence
system that includes a sensor switch for the seat.
These components tell the electrical system if the
operator is sitting on the seat. This system will stop
the engine when the operator leaves the seat. For
your protection, always make sure this system
operates correctly.
NOTE: The engine was shipped from the factory filled
with oil. Check the level of the oil. Add oil as needed.
See the engine manufacturer’s instructions for the type
of fuel and oil to use.
1. Push the clutch/brake pedal completely forward.
Keep your foot on the pedal.
2. Make sure the speed control pedal is in the NEU-
TRAL position.
3. Make sure the blade rotation control is in the
DISENGAGE position.
4. Move the throttle control completely forward to the
CHOKE or FAST position.
Operation
en
1
2
3
Figure 20
Operate on Hills
WARNING
Do not ride up or down slopes that are too steep to
back straight up. Never ride the unit across a slope.
1. Before you ride up or down a hill, move the speed
control pedal lever to the slowest speed.
2. Do not stop or change speed settings on a hill. If
you must stop, quickly push the clutch/brake pedal
forward and set the parking brake.
3. To start again, make sure the speed control is in
the slowest speed.
a. Move the throttle control to the SLOW position.
b. Slowly engage the speed control pedal.
4. If you must stop or start on a hill, always have
enough space for the unit to roll when you release
the brake and engage the clutch.
5. Be very careful when you change directions on a
hill. When on a slope or in a turn on a hill, move the
throttle control to the SLOW position to help pre-
vent an accident.
5. Turn the ignition key to the START position (see
Figure 18).
NOTE: If the engine does not start after four or five
tries, move the throttle control to the FAST position.
Again try to start the engine. If the engine will not start,
see the TROUBLESHOOTING CHART.
6. Slowly move the throttle control to the SLOW
position.
7. To start a hot engine, move the throttle control to a
position between FAST and SLOW.