BA_M-SHEV_EN_17
www.simon-protec.com
Date: 30.07.2019
Issue: 1.7/07.2019
Page 19
Mechanical connection
3 Mechanical connection
3.1 M-SHEV-10-AP
Mark the positions of the mounting points of the
M-SHEV-10-AP (see Figure 14: “Mounting points”).
Drill the holes.
Fasten the M-SHEV-10-AP through the bottom of the
housing using four screws suitable for the respective
mounting surface (not supplied).
Figure 14: Mounting points
3.2 M-SHEV
Remove the 4 plastic caps on the back of the M-SHEV
housing.
Mark the positions of the housing’s direct mounting
points for the M-SHEV (see Figure 15: “Mounting points
(back of housing)”) or mount the four wall fixing lugs (see
Figure 16: “Wall fixing lugs”) supplied to the housing and
then mark the positions of the mounting holes to be
drilled.
Drill the holes.
Fasten the M-SHEV with four suitable screws (not sup-
plied) through the bottom of the housing or, if used, with
the aid of four wall fixing lugs.
Figure 15: Mounting points
(back of housing)
Figure 16: Wall fixing lugs
ATTENTION
The openings of the battery cells (round lids on top of the
batteries) must not point downwards, because this would
lead to a leak out of the battery!
ATTENTION
Do not connect the battery during installation!
Mounting points
Mounting points
