Simex SRP-946, User Manual

Page: 52 / 62

User manual - METER SRP-946
Register Write Range Register description
2Bh Yes see descr.
“ t h2 ” parameter in “ InPt ” menu, no decimal point included – lower
word
2Ch Yes see descr.
“ t h3 ” parameter in “ InPt ” menu, no decimal point included – higher
word
2Dh Yes see descr.
“ t h3 ” parameter in “ InPt ” menu, no decimal point included – lower
word
2Eh Yes see descr.
“ t d ” parameter in “ InPt ” menu, no decimal point included – higher
word
2Fh Yes see descr.
“ t d ” parameter in “ InPt ” menu, no decimal point included – lower
word
30h Yes see descr.
“
t Sn
” parameter in “
InPt
” menu, no decimal point included – higher
word
31h Yes see descr.
“ t Sn ” parameter in “ InPt ” menu, no decimal point include – lower
word
32h Yes see descr.
“ t Sh ” parameter in “ InPt ” menu, no decimal point included – higher
word
33h Yes see descr.
“ t Sh ” parameter in “ InPt ” menu, no decimal point included – lower
word
34h Yes 0 ÷ 1 “ AL ” parameter in “ bEEP ” menu: 0 - off; 1 - on
35h Yes 0 ÷ 1 “ R1 ” parameter in “ bEEP ” menu: 0 - off; 1 - on
36h Yes 0 ÷ 1
“
R2
” parameter in “
bEEP
” menu:
0
- off;
1
- on
37h Yes 0 ÷ 1 “ R3 ” parameter in “ bEEP ” menu: 0 - off; 1 - on
38h Yes 0 ÷ 1 “ R4 ” parameter in “ bEEP ” menu: 0 - off; 1 - on
39h Yes 1 ÷ 8
“ bri ” parameter (display brightness);
1 - the lowest brightness; 8 - the highest brightness
3Bh
Yes 0 ÷ 1
“ Edit ” parameter (numerical parameters edit mode);
0 - „ dig ” mode; 1 - „ SLid ” mode
3Ch Yes see descr.
“ SEtP ” parameter in “ rEL1 ” menu, no decimal point included –
higher word
3Dh Yes see descr.
“ SEtP ” parameter in “ rEL1 ” menu, no decimal point included – lower
word
3Eh Yes see descr.
“ HySt ” parameter in “ rEL1 ” menu, no decimal point included –
higher word
3Fh Yes see descr.
“ HySt ” parameter in “ rEL1 ” menu, no decimal point included –
lower word
40h Yes 0 ÷ 5
“ modE ” parameter in “ rEL1 ” menu:
0 - “ noAC ” mode; 1 - “ on ” mode; 2 - “ oFF ” mode; 3 - “ in ” mode;
4 - “ out ” mode; 5 - “ modb ” mode
41h Yes 0 ÷ 999
“t on” parameter in “rEL1” menu, expressed in tenth of seconds or
tenth of minutes depend on “unit” parameter - register no. 43h)
52