Simex SRP-946, User Manual

Page: 56 / 62

User manual - METER SRP-946
Register Write Range Register description
D1h 1 Yes see descr.
“ OUtL ” parameter in “ OUtP ” menu, no decimal point included –
higher word
D2h 1 Yes see descr.
“ OUtL ” parameter in “ OUtP ” menu, no decimal point included –
lower word
D3h
1
Yes see descr.
“ OUtH ” parameter in “ OUtP ” menu, no decimal point included –
higher word
D4h 1 Yes see descr.
“ OUtH ” parameter in “ OUtP ” menu, no decimal point included –
lower word
D5h 1
Yes see descr.
“ Lo r ” parameter in “ OUtP ” menu, for active current output and
active voltage output, expressed in 0.001% – higher word
Yes see descr.
“
Lo r
” parameter in “
OUtP
” menu for passive current output,
expressed in 0.001% – higher word
D6h 1
Yes see descr.
“ Lo r ” parameter in “ OUtP ” menu, for active current output and
active voltage output, expressed in 0.001% – lower word
Yes see descr.
“ Lo r ” parameter in “ OUtP ” menu for passive current output,
expressed in 0.001% – lower word
D7h 1
Yes see descr.
“ Hi r ” parameter in “ OUtP ” menu for active and passive current
output, expressed in 0.001% – higher word
Yes see descr.
“ Hi r ” parameter in “ OUtP ” menu for active voltage output,
expressed in 0.001% – higher word
D8h 1
Yes see descr.
“ Hi r ” parameter in “ OUtP ” menu for active and passive current
output, expressed in 0.001% – lower word
Yes see descr.
“
Hi r
” parameter in “
OUtP
” menu for active voltage output,
expressed in 0.001% – lower word
D9h 1
Yes 0 ÷ 3
“ AL ” parameter in “ OUtP ” menu (active current output value on
critical exception):
0
- no change;
1
- 22.1 mA;
2
- 3.4 mA;
3
- 0 mA
Yes 0 ÷ 2
“ AL ” parameter in “ OUtP ” menu (passive current output value on
critical exception): 0 - no change; 1 - 22.1 mA; 2 - 3.4 mA
Yes 0 ÷ 5
“ AL ” parameter in “ OUtP ” menu (active voltage output value on
critical exception): 0 - no change; 1 - 11 V; 2 - 5.5; 3 - 1.2 V;
4 - 0.6 V; 5 - 0 V
1 - these registers are active only if device is equipped with current or voltage output
2 - after writing to register no 20h the device responds with an “old” address in the message.
3 - after writing to register no 22h the device responds with the new baud rate.
4 - the value of the “ mbAc ” parameter is also connected to write to this register, so it is possible to block a writes, but
impossible to unblock writes via RS-485 interface, The unblocking of the writes is possible from menu level only.
5 - the pairs of „ X - Y ” coordinates may be defined for any free point. The pair is “free” (it means that particular point is
not defined) if „ X ” coordinate of this point is equal 8000h. After writing both X and Y coordinate the point is defined
and used in calculation of result. The coordinates of any point can be changed at any time.
56