Sime PLANET 25 BFT TS, Manual

Page: 118 / 212

116
IT
ES
PT
GB
RO
RUS
into account the parameters given in the
Table 2 .
2.9 FORCED OUTLET
(B
22-52
type)
Comply with the following requirements
during installation:
–Insulate the exhaust pipe and install a
condensation collection system at the
base of the vertical pipe.
–If the pipe passes through combustible
walls, insulate the section of the flue pipe
passing through the wall with a 30 mm
thick fibreglass pipe covering with a den-
sity of 50 kg/m
3
.
This discharge configuration for models
“25 BFT TS” can be set up with the special
kit (code 8093000). For instructions on
how to perform the assembly operation
with the kit, see paragraph 2.9.1. Protect
the suction side with the optional accessory
(code 8089501, figure 17). The kit (code
8093000} is supplied with a suction diaph-
ragm which must be used as specified in
figure 13/a, depending on the maximum
acceptable loss.
The maximum length of the duct is deter-
mined by the load losses of the single
accessories fitted (excluding the splitter)
and should not exceed 7.00 mm H
2
O.
For information on how to calculate the load
of single accessories, see Table 2 .
cod. 8089501
Fig. 17
Fig. 16
KEY
1 Air-smokes flow splitting unit with take-off points code 8093000
2 a 90° elbow MF code 8077410 (6 pz.)
2 b Isolated 90° elbow MF code 8077408
3 a Extension L.1000 code 8077309 (6 pz.)
3 b Isolated extension L.1000 code 8077306
3 c Extension L.500 code 8077308 (6 pz.)
4
Int.-est. ring kit code 8091500
5 Intake terminal code 8089500
6 Locking junction code 8092700 (5 pz.)
7 Doubler fitting code 8091400
8 Tile with articulated joint code 8091300
9 Roof outlet terminal L. 1390 code 8091201
10 45° elbow MF code 8077411 (6 pz.)
11 Condensation outlet L. 135 code 8092800
12 Tee condensation outlet code 8093300