GB
8
Problem
Possible cause
Solution
Tool operating slowly
Pressure incorrect
Set the correct air pressure according to the specification
Dirt within the mechanism
Pour oil into air inlet as per maintenance instructions
Air blockage
Operate tool in short bursts to clear blockage
Air leak
Check all fittings and hose for air leaks and correct issue by re-tightening, using
PTFE tape or replacing
Tool seized
Dirt or rust in mechanism
See ‘Tool operating slowly’ solutions
Dirt or rust in mechanism
Tap tool gently with a soft mallet
Dirt or rust in mechanism
Free mechanism by rotating drive manually when disconnected from air line
Strong vibrations when tool is
switched on
Accessory fitted incorrectly
Remove accessory, inspect for damage and refit
Accessory damaged (cracks, deformations or splinters)
Replace cutting accessory
Spindle bent
Have the tool repaired by an authorised Silverline service centre
Tool will not stop after trigger is
fully released
Throttle valve O-ring or valve seat damaged
Have the tool repaired at an authorised Silverline service centre
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
633630_MANUAL.indd 8
31/05/2017 08:38
Summary of Contents for 633630
Page 2: ...2 Fig A Fig B 3 1 2 3 4 5 6 7 8 633630_MANUAL indd 2 31 05 2017 08 38...
Page 7: ...Air Micro Grinder Kit 633630 7 silverlinetools com 633630_MANUAL indd 7 31 05 2017 08 38...
Page 25: ...Mini amoladora neum tica 633630 25 silverlinetools com 633630_MANUAL indd 25 31 05 2017 08 38...
Page 37: ...Stift freesmachine 633630 37 silverlinetools com 633630_MANUAL indd 37 31 05 2017 08 38...