Silicon CPV plc
Akhter House, Perry Road, Harlow, Essex, CM18 7PN, UK
Tel +44 (0) 1279 821200 Email [email protected]
Page 15 of 32
Installation Instructions for Badr – Part 2
The mode selection switch is located on the PCB moulding on the battery
pack. During normal operation the mode switch is hidden due to the
insertion of a weather seal rubber plug. The plug can be easily pulled out
to show the mode switch (see fig 1). Please ensure the rubber plug is re-
inserted after inspection to prevent water ingress. Using a small flat
bladed screw driver (fig 2), change the switch to the following modes of
operation (fig 3):
Mode selection
1.
On Mode – This is the normal operating position. Please ensure
that when the Street Light is installed the mode switch is ALWAYS in
this position.
2.
Ship Mode – This position is selected when the unit is not in use.
This is typically when the unit is stored or packed and being
transported to site for installation. The controller automatically
enters a power down state to conserve battery power
3.
Test Mode - This position is used to check the operation of the light
under test conditions. This should not be selected for normal light
operation.
