Silicon CPV plc
Akhter House, Perry Road, Harlow, Essex, CM18 7PN, UK
Tel +44 (0) 1279 821200 Email [email protected]
Page 12 of 32
Installation Instructions for Kamr – Part 2
Fixing the Solar Street Light to the Pole
Warning: During the installation of the street light please observe safe
working practices when working at height.
Please complete the following steps below to correctly install the Kamr
Solar Street Light
1.
For this task you will need a powered drill with a 4.5mm HSS drill
bit and the 3 off Security Self Tappers Pin Torx BH - 10 x 3/4" (4.8
x 19mm) supplied in the light carton
2.
Mount the street light on the pole as shown below and correctly
align with the road
3.
Drill three pilot holes equally spaced around the circumference of
the pole and approximately 80mm from the light head
4.
With the screws supplied fix the light to the pole
5.
Ensure the mode switch is set to “ON” and insert the rubber plug
Security Screw
Light with Pole
adaptor
