Silex technology MNS-300EM, Command Manual

Page: 70 / 134

58
MNS-300EM Command Manual
6-2-3. SET PORT S1 ECADDR
Sets the primary destination address for E-Cable connection.
SET PORT S1 ECADDR <dest-addr>
For <dest-addr>, enter the primary address (IP address) of the host device to which the I/O
port data is sent. When DNS is enabled only for the TCP mode, a host name can be used to
enter the command.
When 0.0.0.0 is entered, no data can be sent.
The factory default value is
0.0.0.0
.
6-2-4. SET PORT S1 ECCONN
Sets the interval for connection retry in case TCP connection is lost or cannot be
established. This setting is valid for TCP mode only.
SET PORT S1 ECCONN <n>
Specify the interval of connection retry for <n>.
The configurable time unit and interval will vary depending on the ECTMMSEC setting that
is enabled/disabled by
SET PORT S1 ECTMMSEC.
When ECTMMSEC is enabled : The valid range is 20-2550. (Unit: Millisecond).
When ECTMMSEC is disabled : The valid range is 1-255. (Unit: Second).
When a value out of the valid range is specified, the upper or lower limit of the range will
be applied. The factory default value is
30 (seconds).
When 0 is given for <n>, the default value (30) will be applied.