![Silex technology MNS-300EM Command Manual Download Page 63](http://html1.mh-extra.com/html/silex-technology/mns-300em/mns-300em_command-manual_1271326063.webp)
6. Port Commands
51
6-1-3. SET PORT S2 COnsole
6-1-4. SET PORT S1 CONSTR
Enables/Disables the console mode for the serial port 2.
SET PORT S2 CONsole [ENable | DISable]
ENable
: Enables the console mode.
DISable
: Disables the console mode.
This command can be used only for the serial port 2.
The factory default value is
ENable
.
Sets a character string to switch on the console mode for a serial port.
SET PORT S1 CONSTR <string>
For <string>, enter the character string to switch on the console mode.
When the serial port is in the trap mode and the string defined by this command is entered
on the serial port, the serial port will enter into the console mode.
In the console mode, the MNS-300EM's settings can be configured from the serial port.
When no string is defined, this function is disabled and the configuration cannot be
changed via the serial port. The maximum length of the string is 31 bytes.
When non-printable characters are desired in the string, then the value should be prefixed
with
\x
and each byte should be defined with two hex characters. The binary equivalent of
the two hex characters will be used when scanning the input for a match.
To enable the specified value, MNS-300EM needs to restart.
The factory default value is
+++
.
Summary of Contents for MNS-300EM
