Optika
Operating manual - English
Copyright Silca 2017
21
6.1.4
SPECIAL CASES
a) SMALL FLAT KEY - HEAD STOP (WITH PLASTIC HEAD)
If the distance between the end of the plastic part and the stop is small, impeding proper viewing of the
stop cursor, proceed as follows:
1) Lower the clamp-opening lever (B) and without exerting pressure fit the key into the clamp until the
stop is visible (fig. 27-1) and the cursor is in the right position.
2) Align the upper bar and press ENTER; in this way the stem length reading is precise.
3) Pull the key out slightly (fig. 27-2), release the clamp-opening lever to keep the key in place, then with
the alignment bar centred and illumination bar up, press ENTER.
Fig. 27
b) VEHICLE KEY WITH LASER TYPE CUTS
With a cut key the profile is read properly and recognized only if the cuts have not touched or altered
the part used for recognition.
Fig. 28
B
1
2
KEY-BLANK profile
CUT key profile
search result: OK
CUT key profile
search result: NEGATIVE
