Operating manual - English
Optika
12
Copyright Silca 2017
5.4.1
Key insertion
1) Take hold of the key head with one hand and with the
other lower the clamp opening lever (fig. 13).
2) With the clamp open fit the key, taking care that:
- the key is well centred on the clamp (not too far to
the right or left) (fig. 18).
- it is aligned as well as possible (not turned right or
left) (fig. 16).
3) For bit keys make sure the key head is aligned
horizontally (see fig. 23, page 18).
Fig. 13
5.4.2
Bit key insertion with ligth shade device
Opening the light shade device:
Hold the side of the adapter and lift
the closing tab.
Closing the light shade device:
Insert the key to be dimmed and
close the adapter by lowering the
lever until it clicks into place.
Fig. 14 - light shade device
5.4.3
Key removal
Removing
Note: the key must be removed only when the
clamp is open. Removing it with the clamp
closed will damage the illuminators and the key
plate (glass).
1) Take hold of the key head with one hand and
with the other lower the clamp opening lever
(fig. 15).
2) With the clamp open, lift the key in it so that the
glass plate is not scratched and remove the
key.
3) Release the clamp opening lever.
Fig. 15