Fig. 46
Fig. 47
Fig. 48
6.8 Replacing and/or adjusting tension on the belt
Worn or loose belts must be replaced or adjusted so as to ensure safe and proper operation of the cutting tool/
brush.
ATTENTION: remove the mains plug.
1) Turn the machine onto its back and loosen the 4
nuts (M4) (chap. 6.7).
2) Re-position the machine on the workbench.
3) Remove the cover (P) by loosening the screws
(P1) (Fig. 45).
4) Move the motor towards the cutter and remove
the worn belt.
5) Fit the new belt.
6) Push the motor to the back until the belt has the
right tension.
7) Tighten the four screws (M1) and the 4 nuts (M4).
8) Place the motor cover (P) and secure with the 3
screws (P1).
Fig. 49
Operating manual
FASTBIT
Copyright Silca 2014
27
