6.3 Replacing the tracer point
ATTENTION: remove the mains plug.
1) Loosen and remove screw (E2), plate and worn tracer point.
2) Fit the new tracer point with the plate and push all the way.
3) Tighten the screw (E2).
4) Re-calibrate the machine, following the procedure described in chap. 4.4.
E2
E
Fig. 37
6.4 Replacing the fuses
ATTENTION: disconnect the power lead from the mains and machine.
1) Remove the fuses box from the key-cutting machine socket (R) (Fig. 38).
2) Replace the fuses (R1).
3) Close the fuses box and connect the power cable.
ATTENTION: fuses must always be replaced with others of the same type and with the same Amps
(4 Amp rapid).
Fig. 38
Operating manual
FASTBIT
Copyright Silca 2014
24
