6.7
Replacing the motor
ATTENTION: remove the mains plug.
1) Access the lower compartment (see chap. 6.5).
2) Disconnect the 2 connectors (H2). Loosen the nut (T1) and
disconnect the earthing wire (Fig. 43).
3) Remove the wire tie.
4) Loosen and remove the 4 motor fi xing nuts (Fig. 44).
5) Re-position the machine on the workbench.
6) Remove the screws (P1), then the protective cover (P) (Fig.
45).
7) Unscrew the wire grommet (M3) (Fig. 46).
8) Remove the 4 motor fi xing screws (M1) and pull off the belt.
9) Loosen the grub screw (S1) and remove the drive pulley (Fig.
47).
10) Pull out the motor cable and remove the motor (Fig. 48).
11) the new motor, the 4 screws (M1) and 4 nuts (M4).
12) Fit the drive pulley onto the new motor and secure with the grub
screw (S1).
13) Fit the belt and adjust tension, tighten the 4 screws (M1) and 4
motor fi xing nuts (M4).
Fig. 43
14) Pass the motor cable through the grommet (M3).
15) Connect the 2 connectors (H2) to the switch (H) and secure the earthing wire to its screw with a nut (T1).
16) Replace and secure the metal bottom (W) (chap. 6.5).
17) Replace the protective cover (P) and secure with the 3 screws (P1).
Fig. 44
Fig. 45
Operating manual
FASTBIT
Copyright Silca 2014
26
