5.3 Cutting keys with central stop
NOTE: check that the carriage is locked into the fi xed horizontal position (chap. 5.1).
1) Loosen the clamp handles slightly to allow the keys to enter.
2) Insert the original key into the left-hand clamp with the
central stop up against the clamp (left-hand side) and the
bit parallel to the clamp (Fig. 28); tighten the handle (J1) to
secure the key.
3) Insert the key to be cut into the right-hand clamp with the
central stop up against the clamp (left-hand side) and the
bit parallel to the clamp; tighten the handle (J1) to secure
the key.
4) Start the machine with switch (K) and proceed with cutting.
5) Move the carriage with lever (A) to take the original key
cuts into contact with the tracer point.
6) Pull the carriage back and go on to another cutting point,
then continue as for point 6.
7) When cutting is fi nished, turn off the switch (K) and remove
the keys.
Fig. 28
Fig. 29
J1
Operating manual
FASTBIT
Copyright Silca 2014
19
