12
PARTS REMOVAL & REPLACEMENT
FEEDWHEEL AND GRIPPER PLUG
1. Place the tool on its side and remove the
two socket head cap screws (75) from the
weld housing (24).
2. Pull upward on the weld housing and
raise it slightly.
3. Insert a thin rod or screwdriver and
disengage the torsion spring (23) from
the tab on the weld housing (24).
4. Pull the weld housing off the tool.
5. Lift the feedwheel (22) from the feedwheel
shaft (21).
6. Lift the torsion spring (23) and the
tensioner foot (16) off the support pin
(25). This allows the gripper plug (17) to
be replaced if necessary. Turn the
tensioner foot over, remove the flat head
cap screw (19) and with a small punch,
drive the roll pin (20) upward to remove
the gripper plug and strap guide, (18).
7. Replace the feedwheel if necessary,
making sure the hollow face of the
feedwheel faces inward.
8. Lubricate the support pin and the end of
the feedwheel shaft with Mo-Lith No. 2
lubricant to allow the tensioner foot to
pivot freely.
9. Reassemble the parts in reverse order if
further parts removal and replacement
are not needed.
Summary of Contents for TENSION-WELD VXL-2000-Z
Page 1: ...VXL 2000 Z and VXM 2000 Z TENSION WELD STRAPPING TOOLS...
Page 29: ...29...
Page 38: ...38...
