15
FIGURE-A
FIGURE-B
FIGURE-C
FIGURE-D
NEEDLE BEARING (ECCENTRIC SHAFT)
Use a 1/4-20x3 socket head cap screw and an
extra spacer (86) to remove the needle
bearing (29) from the back of the gear
housing (72).
1. Thread extra spacer (86) on to the SHCS
approximately 3/16" to 1/4" from the end.
2. Insert the screw and spacer through the
seal (58) and into the needle bearing.
With the gear housing firmly braced,
strike the end of the screw firmly with a
hammer to drive the bearing into the
spacer. This action will prevent the
spacer from rotating while screw is
threaded in.
3. Remove the extra spacer from the SHCS
and thread the screw into the spacer.
Clamp the screw head in a vise and
lightly tap the gear housing to extract the
bearing, spacer and seal.
Only replace the bearing, spacer and seal
with new components.
ASSEMBLY NOTES:
A. When installing spacer (86) be sure that it
is squarely aligned at the bottom of the
bore.
B. When installing bearing (29), the text side
should face away from the gear housing.
Install the bearing flush to the housing
surface. Failure to set the bearing flush
with the housing will result in
interference with the slider link (48).
C. When installing seal (58), the seal lips
should face inwards towards bearing.
Install seal flush to housing surface.
Summary of Contents for TENSION-WELD VXL-2000-Z
Page 1: ...VXL 2000 Z and VXM 2000 Z TENSION WELD STRAPPING TOOLS...
Page 29: ...29...
Page 38: ...38...
