Managed Ethernet Switch
User’s Manual 16
Installation
This chapter gives step-by-step instructions about how to
install the switch:
Selecting a Site for the Switch
As with any electric device, you should place the switch
where it will not be subjected to extreme temperatures,
humidity, or electromagnetic interference. Specifically, the
site you select should meet the following requirements:
-The ambient temperature should be between 32
℉
to 113
℉
(0°C to 45
℃
).
-The relative humidity should be less than 95 percent, non-condensing.
-Surrounding electrical devices should not exceed the electromagnetic field
(RFC) standards.
-Make sure that the switch receives adequate ventilation. Do not block the
ventilation holes on each side of the switch.
Connecting to Power
AC power supply:
Step 1:
Connect the supplied AC power cord to the receptacle on the back
of the switch, and then plug it into a standard AC outlet with a
voltage range from 100 to 240 VAC. Turn on the AC power switch
at the back panel to turn on the switch.
Step 2: Turn off the AC switch if you want to shut down the switch.
Summary of Contents for 065-7734
