en
Faults and what to do about them
28
Filter in the water supply is
blocked
1.
Release water pressure in the supply
hose:
a) Turn off the tap.
b) Select any programme (except
q
Rinse/Spin
0
).
c) Touch the
I
button. Allow the
programme to run for approx. 40
seconds.
d) Press the
#
button. The
appliance is switched off.
e) Pull out the mains plug.
2.
Clean the filters:
a) Disconnect the hose from the
tap.
Clean the filter with a small brush.
b) For standard and Aqua-Secure
models, clean the filter on the
rear of the appliance:
Disconnect the hose from the
rear of the appliance.
Use pliers to remove the filter and
then clean it.
3.
Connect the hose and check for
leaks.
3
Faults and what to do
about them
Faults and what to do about them
Emergency release
E.g. in the event of a power cut
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the appliance door can be
opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
and laundry.
If possible, leave it to cool down first.
Caution!
Risk when reaching into/gripping the
rotating drum!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Caution!
Water damage!
Any escaping water may cause water
damage.
Do not open the door if water can be
seen through the glass.
1.
Switch off the appliance. Pull out the
mains plug.
2.
Drain the water
.
3.
Pull the emergency release
downwards with a tool and release.
The door can then be opened.
www.devicemanuals.eu/
