Faults and what to do about them
en
29
Information on the Touch-Display
Display
Cause/Remedy
Œ
■
Flashes fast + signal
: The door was opened and the water level is too high.
Close the door, continue the programme with
I
button or select
q
Rinse/Spin
0
.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
|
■
Flashes
(no water supply): Tap turned on? Filter in the water supply is
blocked?
~
"Filter in the water supply is blocked" on page 28
Is the supply hose kinked or trapped?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E:3610
E:36
alternating display with
-10
and
End
when programme is finished:
■
The drain pump is blocked.
~
"Drain pump is blocked" on page 27
■
The drain hose at the siphon is blocked.
~
"The drain hose at the siphon is blocked" on page 27
E:3510 (Suitable for
special models)
E:35
alternating display with
-10
and
End
when programme is finished: there is
water in the base trough, the appliance is leaking. Turn off the tap. Call customer
services.
E:602b
E:60
alternating display with
-2b
and
End
when programme is finished: unbalance
problem, spinning phase is aborted.
Distribute small and large items of laundry evenly in the drum.
w
lights up
The childproof lock is activated – deactivate it.
f
lights up
Too much foam has been detected and an additional rinse cycle has been activated.
Reduce the basic dosage of
ß
i-Dos for the next washing cycle with the same load.
The indicator lamp of
the
ä
Drum Clean
programme flashes
Run the
ä
Drum Clean
programme to clean and care for the drum and the outer
tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manufac-
turer. Do not use detergent designed for woollens or delicates.
■
Switching the information signal on/off.
~
"Switching the drum-care information signal on/off" on page 24
Other displays
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer services.
www.devicemanuals.eu/
