Operating the appliance
en
17
Selecting the programme
additional settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The indicator lamp for the button lights
up if a setting is actived.
The settings are not saved when the
appliance is switched off.
Programme additional settings
~
Page 14
Overview of programmes
~
Supplementary sheet for the operating
and installation instructions.
Placing laundry into the drum
:
Warning
Risk of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the appliance.
Hand-rinse these items of laundry
thoroughly beforehand.
Notes
■
Mix items of laundry of varying sizes.
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual laundry
items may cause an unbalanced
load.
■
Observe the maximum specified
load. Overfilling adversely affects the
washing result and promotes
creasing.
1.
Unfold presorted laundry items and
place them in the drum.
2.
Make sure that no items of laundry
are trapped between the door and
the rubber seal, and close the door.
Measuring and adding
detergent and care products
For the majority of programmes on your
appliance, detergent and fabric softener
are dosed automatically; it is a factory
setting for these programmes and can
be changed.
In addition to intelligent dosing, you can
add cleaning aids (e.g. softener, bleach
or stain remover) to the left-hand
compartment , if necessary.
For programmes without intelligent
dosing, or as required (in which case,
set intelligent dosing to "off"), detergent
can be added manually to the left-hand
compartment.
Starting the programme
Select the
I
button. The indicator lamp
lights up and the programme starts.
The
Finish in
is shown in the Touch-
Display and counts down until the
programme starts. After the washing
programme has started, the programme
duration is displayed. And the displays
for the programme's progress light up.
~
"Control panel" on page 9
Note:
Foam detection
If the symbol
f
also lights up in the
Touch-Display, the appliance has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
If you want to lock the programme to
prevent it from being adjusted
inadvertently, you can select the
childproof lock.
www.devicemanuals.eu/
