Positioning and connecting
en
37
Caution!
Damage to the appliance/fabrics
If the end of the drain hose is immersed
in the drained water, water may be
sucked back into the appliance and may
damage the appliance/fabrics.
Make sure that:
■
The plug does not block drainage
from the washbasin.
■
The end of the drain hose is not
immersed in the drained water.
■
The water drains away quickly
enough.
Note:
Do not kink the water drain hose
or put strain on it lengthways.
Connection
■
Drainage into a washbasin
■
Drainage into a siphon
The connection point must be
secured using a hose clamp with a
diameter of 24 - 40 mm (available
from specialist dealers).
■
Drainage into a plastic pipe with
rubber bushing or into a drainage
pit
Alignment
Level the appliance using a spirit level.
Incorrect levelling may result in intense
noise, vibrations and “wandering”.
1.
Loosen the lock nuts using a
wrench, by turning it in a clockwise
direction.
2.
Check the alignment of the
appliance with a spirit level, and
adjust it if necessary. Change the
height by turning the appliance feet.
All four appliance feet must stand
firmly on the ground.
3.
Tighten the lock nut against the
housing.
In doing so, hold the foot tight and
do not adjust its height.
The lock nuts on all four appliance
feet must be screwed tightly against
the housing.
www.devicemanuals.eu/