Siemens SITRANS LUT400, Operating Instructions Manual

Page: 518 / 601

A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS Page 205
mmm
mm
Pa
ra
m
e
te
rs
3.3. Maintenance
3.3.1. Transducer Enable
Enables/disables transducer from taking measurements.
Set parameter to Disabled to stop transducer from measuring while calibration
or maintenance work is performed. Set to Enabled to restart measurements
after calibration or maintenance complete.
3.3.2. Backup Control
LUI only. Determine source of configuration recovery file when sensor has been
replaced.
When sensor unit has been replaced, fault code 132 is displayed to note that LUI
backup file does not match configuration file in sensor. To clear fault, set
Backup Control option to location from where parameter configuration should
be read; from the LUI backup file or from the new sensor.
Note: Default settings in the parameter tables are indicated with an asterisk (*)
unless explicitly stated.
Options
* ENABLED
DISABLED
Notes:
• An Echo Profile (3.2.1.) cannot be requested from LUI when Transducer
Enable (3.3.1.) is set to DISABLED. The local push button will not operate.
• When Transducer Enable (3.3.1.) is set to DISABLED, the LOE fault will
display immediately.
• If Transducer Enable (3.3.1.) is set to DISABLED and power to the device is
turned off, Transducer Enable (3.3.1.) will be reset to ENABLED when
power is restored.
Options
* DONE
No change required (no fault displayed), or oper-
ation is complete
FROM SENSOR
Sensor parameters will be used as is, and LUI
will receive these parameters as backup.
FROM LUI
Recovery of sensor parameters will come from
LUI backup.