Siemens SITRANS LG250, Operating Instructions Manual, Page: 54 / 92

54 PBD-51041388 SITRANS LG250 - Operating Instructions
46201-EN-150424
Menu item Default value Modified value
Device memory - Measured value memory - Start
with measured value
Not active
Device memory - Measured value memory - Stop
with measured value
Not active
Device memory - Measured value memory - Stop
recording when memory is full
Not active
Additional adjustments
Menu item Default value Modified value
PIN 0000
Date Actual date
Time Actual time
Time - Format 24 hours
Probe type Device-specific
HART mode Analogue current output
The instrument settings are copied with this function. The following
functions are available:
•
Read from sensor: Read data from sensor and save in the display
and adjustment module
•
Write to sensor: Save data from the display and adjustment mod-
ule back into the sensor
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu " Setup " and " Display "
•
In the menu " Additional adjustments " the items " Reset, Date/Time "
•
Special parameters
The copied data are permanently saved in an EEPROM memory in
the display and adjustment module and remain there even in case of
power failure. From there, they can be written into one or more sen-
sors or kept as backup for a possible electronics exchange.
Note:
Before the data are stored in the sensor, a check is carried out to
determine if the data fit the sensor. If the data do not fit, a fault signal
is triggered or the function is blocked. When data are being written
into the sensor, the display shows which instrument type the data
originate from and which TAG-no. this sensor had.
In this menu item you can select the type and size of your probe from
a list of all possible probes. This is necessary to adapt the electronics
optimally to the probe.
Additional adjustments -
Copy instrument settings
Additional adjustments -
Probe type