11
PBD-51041388
SITRANS LG250 - Operating Instructions
46201-EN-150424
The instrument is always preset to the application "
Level measure-
ment
".
For the interface measurement, you can select the requested output
signal with the setup.
3.3 Packaging, transport and storage
Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
according to DIN EN 24180.
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. For special versions, PE foam or PE
foil is also used. Dispose of the packaging material via specialised
recycling companies.
Transport must be carried out in due consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
•
Not in the open
•
Dry and dust free
•
Not exposed to corrosive media
•
Protected against solar radiation
•
Avoiding mechanical shock and vibration
•
Storage and transport temperature see chapter "
Supplement -
Technical data - Ambient conditions
"
•
Relative humidity 20 … 85 %
3.4 Accessories and replacement parts
The display and adjustment module LG Local Display Interface is
used for measured value indication, adjustment and diagnosis. It can
be inserted into the sensor and removed at any time.
You can find additional information in the operating instructions
manual "
LG Local Display Interface
" (Document-ID 43838).
The LG Remote Interface is an external display and adjustment unit
for sensors with single chamber housing and Ex-d double chamber
housing.
It is suitable for measured value indication and adjustment of sensors
and is connected to the sensor with a four-wire standard cable up to
50 m (164 ft) long.
Output signal
Packaging
Transport
Transport inspection
Storage
Storage and transport
temperature
Display and adjustment
module
External display and
adjustment unit